| MAIN | SHOP | VIDEO |
ОПИСАНИЕ НА РУССКОМ НИЖЕ!!!
Attention!!!
If you are unable to make a purchase, check your email. There will be a message with links to alternative stores where you can complete your purchase.
Universal "No Recoil" script for Logitech Mice. This universal script significantly reduces vertical recoil for weapons in games with simple, uniform, and linear recoil patterns—where recoil remains almost the same at the start, middle, and end of shooting. If the recoil pattern is uneven, the script will reduce recoil approximately up to the 10th shot. Your mouse must be compatible with the GHUB software.
The script allows cursor movement speed to be adjusted by default within the range of 1 to 12 pixels. The desired recoil reduction mode is activated using a combination of mouse and keyboard buttons.
The script supports recoil reduction for automatic, semi-automatic, and sniper weapons. Different modes for these weapon types can be activated using specific mouse and keyboard button combinations.
Fine-Tuning Recoil Reduction:
The script includes three adjustable lines for each weapon, enabling you to customize recoil settings for specific weapons. Once configured, you can save the settings, so, for example, the 5th mouse button activates the recoil reduction mode for the M416, and the 4th button for the AKM.
# Weapon #1 -> 5th mouse button:
delay_ms_1 = 10 # Delay in milliseconds. Increase if the crosshair moves down while shooting, decrease if it moves up.
moveX_1 = 0 # Horizontal adjustment. Positive value if the crosshair moves left, negative if it moves right.
moveY_1 = 1 # Vertical adjustment. Positive value if the crosshair moves up, negative if it moves down.
Script Controls:
CapsLock: Enables/disables the script. Pressing the CapsLock key on the keyboard will light up the CapsLock indicator and activate the script. Pressing CapsLock again will turn off the script, and the indicator will go off.
1 pixel: 5th mouse button.
2 pixels: 4th mouse button.
3 pixels: Left Shift + 5th mouse button.
4 pixels: Left Shift + 4th mouse button.
5 pixels: Left Alt + 5th mouse button.
6 pixels: Left Alt + 4th mouse button.
7 pixels: Left Ctrl + 5th mouse button.
8 pixels: Left Ctrl + 4th mouse button.
9 pixels: Left Shift + Left Alt + 5th mouse button.
10 pixels: Left Shift + Left Alt + 4th mouse button.
11 pixels: Left Ctrl + Left Alt + 5th mouse button.
12 pixels: Left Ctrl + Left Alt + 4th mouse button.
Semi-Automatic Weapon Modes:
Mode #1: Left Shift + Left Ctrl + 5th mouse button.
Mode #2: Left Shift + Left Ctrl + 4th mouse button.
Single-Fire Sniper Weapon Modes:
Mode #1: Left Shift + Left Alt + Left Ctrl + 5th mouse button.
Mode #2: Left Shift + Left Alt + Left Ctrl + 4th mouse button.
When the correct combination of keyboard and mouse buttons is pressed to enable a specific mode, your in-game character will perform a jump as confirmation.
Important Notes:
Compatibility: This script is designed for games where aiming requires holding the right mouse button. Recoil reduction occurs only when both the right and left mouse buttons are pressed. If the right mouse button is not pressed, the left mouse button functions as usual.
Limitations with Logitech Left Mouse Button: Left mouse button actions defined in the script do not work directly on the Logitech left mouse button.
For semi-automatic weapon modes:
Press and hold the right mouse button.
Press the left mouse button to start firing.
Release the right mouse button to stop firing.
In Delta Force, you can't use semi-automatic mode — it will result in a ban.
Problems that happen with Logitech and how to solve them!!!
Attention! How to Avoid a Potential Ban When Using Lua Scripts.
In Warface, Lua scripts for recoil control only work with the old GHUB interface. The new interface likely uses Win32 API, which is detected and blocked by anti-cheat systems. There have already been ban cases in games like StalCraft and Delta Force. The old GHUB is safer because it uses its own driver-based solution.
Download the old, stable version here:
https://drive.google.com/file/d/1ffXNTp5iQZ8woltyIj7CKkeY6Oz6ux3x/view
After installation, disable automatic updates in the settings.
Also, for safety, do not use game-specific profiles in GHUB or Logitech Gaming Software. Use a desktop profile with the persistent attribute.
GHUB must be run with administrator privileges.
Third-party programs that can use the mouse's side buttons, such as Discord, may cause issues with running the scripts, so keep this in mind.
You should also be familiar with your mouse button numbering.
________________________________________
Универсальный скрипт - No Recoil для мышек logitech, почти полностью убирает вертикальную отдачу у оружия в играх с простой, равномерной, линейной отдачей у оружия, это когда отдача в начале стрельбы, в середине стрельбы и ближе концу стрельбы - почти одинаковая.
Если отдача не равномерная, то убирание отдачи приблизительно будет до 10-го выстрела. Ваша мышка должна поддерживаться программой GHUB.
С скриптом скорость опускания курсора по умолчанию регулируется в пределах 1...12 пикселей. Включение необходимого режима убирания отдачи осуществляется с помощью нажатия сочетания кнопок мыши и клавиатуры.
С помощью скрипта можно убирать отдачу не только у автоматического оружия, но и у полуавтоматического, и у снайперского. Эти разные режимы включаются с помощью сочетания кнопок мыши и клавиатуры.
В скрипте есть такие 3 строки для каждого оружия с помощью которых вы может сами отрегулировать убирание отдачи для конкретного оружия, сохранить и тогда например на 5-ю кнопку будет режим убирания отдачи для М416, а на 4-ю для АКМ и.т.д.
-- Weapon #1 -> 5 mouse button:
delay_ms_1 = 10 -> задержка в миллисекундах. Если прицел при стрельбе двигается вниз, то увеличиваете, если верх то уменьшаете.
moveX_1 = 0 -> регулировка по горизонтали. Положительное число если при стрельбе прицел двигается влево и отрицательное, если вправо.
moveY_1 = 1 -> регулировка по вертикали. Положительное число если при стрельбе прицел двигается верх и отрицательное, если вниз.
Управление скриптом:
CapsLock: вкл/выкл скрипта. Нажмите на клавиатуре кнопку CapsLock, загорится значок CapsLock и скрипт включится. При повторном нажатии кнопки CapsLock выключает скрипт, значок CapsLock погаснет.
1 pixel: 5-я копка мыши.
2 pixel: 4-я копка мыши.
3 pixel: левый shift + 5-я копка мыши.
4 pixel: левый shift + 4-я копка мыши.
5 pixel: левый alt + 5-я копка мыши.
6 pixel: левый alt + 4-я копка мыши.
7 pixel: левый ctrl + 5-я копка мыши.
8 pixel: левый ctrl + 4-я копка мыши.
9 pixel: левый shift + левый alt + 5-я копка мыши.
10 pixel: левый shift + левый alt + 4-я копка мыши.
11 pixel: левый ctrl + левый alt + 5-я копка мыши.
12 pixel: левый ctrl + левый alt + 4-я копка мыши.
Режим для полуавтоматического оружия №1: левый shift + левый ctrl + 5-я копка мыши.
Режим для полуавтоматического оружия №2: левый shift + левый ctrl + 4-я копка мыши.
Режим одиночной стрельбы для снайперского оружия №1: левый shift + левый alt + левый ctrl + 5-я копка мыши.
Режим одиночной стрельбы для снайперского оружия №2: левый shift + левый alt + левый ctrl + 4-я копка мыши.
При правильном нажатии сочетания кнопок клавиатуры и мыши для включения нужного режима, то в игре произойдет - прыжок.
ВНИМАНИЕ!!!
Скрипт для игр где прицеливание происходит при нажатии и удержании правой кнопки мыши в нажатом состоянии. То есть, убирание отдачи происходит когда нажата правая кнопка и левая, если правая кнопка не нажата, тогда левая кнопка работает как обычно.
Нажатия левой кнопки мыши написанные в скрипте, не работают на левой кнопке мыши Logitech. Поэтому режим стрельбы для полуавтоматического оружия работает следующим образом: нажимаете правую кнопку мыши и удерживаете правую кнопку мыши в нажатом состоянии, затем нажимаете левую кнопку мыши и начинается стрельба. Чтобы стрельба прекратилась, то вам необходимо отпустить правую кнопку мыши.
В Delta Force скрипты для logitech использовать нельзя, будет бан.
Проблемы которые бывают с Logitech и как их решить!!!
Внимание!!! Как избежать возможного бана при использование lua-скриптов.
В Warface lua-скрипты для устранения отдачи работают только в старом интерфейсе GHUB. Новый интерфейс, вероятно, использует Win32 API и поэтому блокируется анти-читом. В таких играх как: StalCraft и Delta Force уже были случаи бана.
Старый GHUB безопаснее, т.к. использует собственное решение.
Скачать старую, стабильную версию:
https://drive.google.com/file/d/1ffXNTp5iQZ8woltyIj7CKkeY6Oz6ux3x/view
После установки отключите автоматическое обновление в настройках.
Также в целях безопасности не используйте профили для игр в GHUB и Logitech Gaming Software. Используйте профиль рабочего стола с атрибутом постоянный.
Программу GHUB надо запускать с правами администратора.
Сторонние программы которые могут использовать боковые кнопки мыши, например Discord, могут вызвать проблемы с запуском работы скриптов, учтите это.
Ещё вы должны хорошо знать нумерацию кнопок мыши.
После установки старой версии GHUB, то сразу необходимо в настройках программы убрать галочку в пункте – Включить автоматическое обновление.